How Do I Choose the Best Cleaning Franchise?

Manual cleaning can only meet the general cleaning needs of razors, but it is obviously not enough for high-end razors. The lack of maintenance of the cutter head may reduce the efficiency and cleanliness of shaving as the use time increases. Increase the noise generated when the cutter head works. The automatic cleaning center can more thoroughly remove the sebum stains remaining on the blade, and the three functions of cleaning, maintenance and sterilization can be taken into account. Braun was the first manufacturer to introduce the concept of a clean center.

Shaver automatic cleaning center

Efficient sterilization: Alcohol cleaning solution can remove the stubble falling from the shaving. Hygiene cleaning of the shaver, the sterilization rate is as high as 99.999%, which is 10 times cleaner than ordinary water. [1]
Braun shaver 7 series: 790cc-4, 760cc-4
Braun shaver 5 series: 590cc-4, 550cc-4
Braun Shaver 3 Series: 390cc-4, 350cc-4
Braun ° CoolTec Shaver: CT5cc

Installation method of shaver automatic cleaning center

Connect the cleaning center to a power outlet with a dedicated power cord.
Press the replacement button 2 to open the cleaning center housing.
Place the detergent box on a level, stable surface (such as a table).
Carefully open the detergent box cover.
Push the detergent box smoothly into the innermost part of the base of the cleaning center.
Slowly close the case until it locks.
Note: The cleaning fluid capacity display panel 1 will show the capacity in the detergent box:
<High> up to 30 cleanings
Low <low> Up to 7 cleanings left
Empty <empty> need to replace with new box

Charging and cleaning of shaver automatic cleaning center

Insert the shaver down into the Braun Automatic Cleaning Center. (The connector on the back of the shaver needs to be aligned with the connector on the cleaning center)
Use of cleaning center
The cleaning center now charges as needed and analyzes the hygiene status of the shaver. One of the cleaning program lights on the right side of the panel will light up: clean <clean> indicates that the shaver is in a clean state; economical (one water droplet) indicates that simple cleaning is required, and regular (two water droplets) indicates that regular cleaning is required. (Three water droplets) indicates that high intensity cleaning is required.
After the Braun Automatic Cleaning Center has selected any required program, press the start button <start cleaning> and the cleaning will begin. For best results, it is recommended to clean after each shave.
The corresponding indicator light will flash continuously during the cleaning process. Each cleaning process consists of several iterations of cleaning solution rinsing the blade, heating and drying. Based on different cleaning procedures, the entire cleaning process takes from 32 minutes to 43 minutes.
Cleaning procedures should not be interrupted. Please note that the blade may be wet and hot during drying. When cleaning is finished, the blue light <clean> will light up. The shaver is now ready for use. [4]

Razor automatic cleaning center for fast cleaning

If there is not enough time to wait for any of the above automatic cleaning procedures to complete, press the <fast cleaning> button to start the non-baking
Use of cleaning center
Dry quick cleaning program. This process takes only 25 seconds to complete. If the shaver is withdrawn immediately after the end of this procedure, wipe the shaver head with a paper towel to prevent dripping of liquid. [2]

Shaver automatic cleaning center standby mode

10 minutes after the charging or cleaning process is completed, the Braun Full-Automatic Cleaning Center will switch to standby mode and all the indicators will go out.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?