What Are the Different Types of Bindery Jobs?

The financial binding machine is a type of binding equipment widely used in financial documents, bills and other bindings of enterprises and institutions. After years of technical upgrade and structural optimization, the financial binding machine has developed an automatic financial binding machine, a fully automatic financial binding machine, and a high intelligence. Financial stapler and other types. Automatic and intelligent binding of financial bills is achieved, which greatly reduces the workload of financial staff's binding work.

Financial binding machine

The entire operation process can be divided into the steps of punching, automatic tube cutting by the binding machine, pipe punching, and riveting.

One-button automatic binding: drilling, pipe feeding, pipe cutting, pipe mounting, positioning, and riveting are all automated.

1.Replace the riveting tube

Insert the through-pin placed on the top of the binding machine from the feed port, and rotate it clockwise gently 360 ° downwards, so that the remaining nylon tube is sleeved on the through-pin, and pulled out from the feed port with the through-pin, and then inserted Just put a new rivet in place.

2.Clean the drill bit and eliminate the paper scraps

Loosen the wing nut on the sharpening sleeve, pull out the top insert pin, take out the red blade sharpener, insert the bit of the drill bit inward into the sharpening sleeve, so that the end face of the sharpening knife shank is aligned with the end of the sharpening sleeve , Use a wing nut to tighten, insert the top material insert rod into the direction of the end face of the grinding knife sleeve, and squeeze the top of the top material insert rod firmly until the paper scraps in the punching knife are eliminated.

3. Sharpening drill

Insert the cutting edge of the drill bit inward into the sharpening sleeve, align the end of the punching shank with the end of the sharpening sleeve, ensure the reliable positioning of the drill bit, lock with a wing nut, and slowly insert the sharpener into the sharpening sleeve. Until it touches the bit of the drill, turn it to the sharpener 5-6 times in a clockwise direction evenly. Do not use too much force. Remove the drill to see if the point is sharp.