What is the plane?
4 jack aircraft differ in size from 12 to 15 inches (30.48 to 38.1 cm). This is meant only for coarse shaping of the boards; The final shaping of the board is done by smaller hand planes, which less likely to create a tear where the fibers catch and break.
The jack plane should only be used to remove the wood layers on the grain of the board. The cross -cutting boards with the jack plane are not recommended due to the amount of material capable of removing at once. The blade can remove the wood by pulling from the board and leaving large development, which can be deeper than the finished plate size. Maintaining the jack plane smoothly with grain of wood prevents unnecessary cleavage and tearing for smoother surface.Rades. "It's long enough to flatten stocks, but it's small enough to move easily with wood. However, the most popular model of the jack is #5.
The jack plane is a two -handed tool. Shares to be planned must be secured in a vice on the bench to avoid moving at work. The blade must always be kept sharp to work properly and efficiently. The mouth of the jack must also be avoided by the accumulation, so the blade is able to perform its work. The blade must also be properly modified before use.
The blade cutting depth is modified using the adjusting nut. Turn the nut in the clockwise direction causes the blade to protrude from the mouth further. The woodworking desk should not cut too much wood at the same time. The blade angle must always be. This setting is done by moving the lever of the side adjustment to the left or right to maintain the blade level.