What Is a Paper Baler?

The waste paper packing machine is used to squeeze and solidify waste paper and similar products under normal conditions, and use special packaging tape to pack and shape, so that its volume is greatly reduced, so as to reduce the volume of transportation, save freight, and increase benefits for enterprises. Introduced advanced technology and advanced technology of similar products at home and abroad.

Waste paper baler

With the increasing awareness of environmental protection, the waste paper baler has played a great role. It can reuse some waste paper and it is more and more accepted by everyone. The domestic waste paper baler has been continuously innovating. , Continuously following the development of some advanced technologies abroad.

1. Before starting, check whether the appearance of the device is abnormal, whether there are hidden dangers around it, and whether the iron wire or plastic rope is sufficient. After confirming normal, open

1 Main pressure

Cylinder model YG220 / 160-4000 quantity 1 125 tons

Nominal thrust 1250KN 4000mm stroke

2 Bolt

Cylinder model YG125 / 80-60 quantity 1 25 tons

Nominal thrust 250KN, stroke 60mm

3 Opening (closing) door cylinder model YG80 / 50-900 Quantity 1 12 tons

Nominal thrust 120KN, stroke 900mm

4 Material box size (length * width * height) 4200 * 1250 * 1100mm

5 Feeding port specification (length * width) 2200 * 1100mm

6 Bale size (length * width * height) 1250 * 1100 * 1800mm

7 The density that the bale can reach after compression is 500kg / m3

8 hydraulic system working pressure 25.0Mpa (250kgf / cm2)

9 Mass per package 900-1200Kg

10 Power specification 380V / 3Ph, 50Hz

11 Total equipment power 37.5KW

12 Lord

The motor for the waste paper baler includes two parts: a stator and a rotor. The stator of the motor of the waste paper baler is also called an armature, and includes parts such as a machine base, an end cover, an armature core, and an armature winding device. The armature iron core is installed in the inner circle of the machine base, which is the bracket of the generator and is made of cast iron. End caps are installed at the two ends, the upper ring is used for lifting, the round holes at the bottom of the foot are used for mounting bolts, and the ground bolts on the base are used to install the ground wire. In order to dissipate heat and facilitate maintenance, there are ventilation windows on the end caps, which are covered with louvered benefit boards to prevent intrusion of debris. The rotor includes rotor core, rotor (excitation) winding, fan, rotating shaft and other components. The rotor core is the road part of the motor of the waste paper baler. It is made of 1-2M thick steel / stack. The iron core is fixed on the yoke with a plutonium bolt. The yoke is made of a single piece of low carbon and is sheathed on the uranium through a steel plutonium.