What should I know about laying the flag stone?
Technically, laying flag stone is one of the simplest jobs that a domestic landscape painter can do, but the effects are among the most dramatic. Laying the flag stone is the choice of landscape that can change the entire appearance of any given area of the home. Although they are most often associated with terraces, stones can be used in a number of different applications.
Installing the flag stone begins with a selection of an area you would like to remodel and then buy the appropriate stones. In general, the choice of stones similar to depth is the key to making a nice level. While the nature of the flag stone ensures that you never get stones accurate depth, approximation is important. For those who cannot find stones of similar depths, there are other ways to fix the problem. The area should be dug with a shovel and then compensated as well as possible. The Excavated part should be approximately 4 inches (10 cm) deep throughout the area and outlined by forms. Then the sand should be used to fill in several inches (5cm) what has just been dug. After filling with sand, the whole area should be compensated by a board or other tool.
After balancing the sand, there are a few more steps needed before the actual laying of the stone. The next step to lay the flag stone is to water the area and make sure it is well packed with a tamping tool. Then a good landscape fabric should be carried out to prevent weed growth.
Finally, it's time for stones. While laying flag stone can be a difficult task on the back, it is perhaps the simplest part of the project, technically. In some cases, it may be necessary to reduce stones. This can be done with a line of lines where it is necessary to cut a small groove, n to hit this area with a small hammer. This should be all that is needed, because flag stones usually fall apart clean and evenly. If stones are too high or too low, according to whichAdjust the base sand.
After laying all stones, the last steps to lay the flag stone pour sand through the stones to fill in any gaps and then remove the forms. These two steps are a few simplest, but sand is very important. Without filling all the spaces, the stones could move and may even move from the place.