How can I apply stucco to wood?

Before applying stucco to wood, you will need to connect a coat layer to the surface, followed by a wire net. Then apply a thin layer of stucco to the surface of the wire mesh as the base for the final coat. Allow this base material to solidify for one hour and slightly scratched the plaster player. Wait for the basic coat to dry completely and apply the final coat of stucco using a spatula. To avoid cracking, fog the stucco lightly with water when it dries and allows the material to be completely cured. Using roof targets, create a moisture barrier between wood and stucco. Then attach a leaf with a medium measuring wire net using galvanized roof nails. The network material must be safely connected to the wood to adequately support the weight of the stucco. Cover each piece of material to make sure there are no LEFT gaps.

It is important to work on one wall at a time at NANAcceptance of wood stucco. Mix the dry stucco material with water according to the manufacturer's instructions. Use only the quantity needed for each layer to prevent the excess. Apply the stucco to a mere coat on a wire mesh with a surface wall. Use sufficient pressure to push the material using the network and lock it in place.

The next step in applying stucco to wood is to scratch the surface of the material by a plaster player. Allow the material to solidify for about an hour before use. Scratching the surface allows better adhesion of the final layer of stucco. Allow this layer of stucco to dry completely before continuing with the final coat. Stir the surface often with water to prevent it from cracking.

As soon as these steps are completed, use Stucco's final thin coat in the wood using a finishing spoon. If you use a color pigment, add it to the mixture before applying. For the best completed texture, use different pressures and angles and stir the surface regularly until stuccoIt does not completely dry. Each layer of stucco can take several days of drying depending on temperature, humidity and thickness. Leave the material for at least six weeks before applying a seal or color to completely cure the material.