How can I build a whirlpool deck?

The whirlpool deck must be able to support the weight of the hot tub, which is a significantly heavy load. The hot bath deck must therefore be carefully designed and properly supported by blocks and beams secured in the ground. However, before creating the whirlpool deck, the builder must consider several factors: do I first need a building permit? Second, will the deck be built close enough to the right power? And thirdly, how will the hot tub be placed on board? This last question may affect the height and placement of the deck in the yard.

Once the location of the hot tub is determined, it is time to start building. The first aspect is the size: a square deck with an area of ​​8 feet up to 8 feet (2.4 meters and 2.4 meters) holds most of the hot tubs. A perfect square must be determined to create such a hot bath. The pound puts in the corners of the square and then determine the center point of the square. This can be done by typing the chain around the dual and then exceeding the string through the noble bets. These bets and central share will be the placement of concrete legs and tif centers between corner bets. Nine supportive support will be used.

kick holes on the betting. There will be concrete. The creator can pour concrete legs or buy a pre -created. If they pour concrete, the vertical beams can be added directly to the concrete, but must be at the level. Pre -created concrete blocks will have metal cards to which the rays can be connected. The sand should be under his feet for support and equalization.

Once the legs are lying and holes filled with ground for support, place the central column on the center block. Measure the height and trim the other posts to the same height. Place these posts and then place the beam to make sure they are at the level. Once the level has been set, secure the beam to the posts and contributions to the blocks. Repeat this process with external columns and rays. Measure the diagonals at this point to ensure the correct location paprov.

Secure all rays together with bindings and nails. Then secure the 2 x 6 plate (0.6 x 1.8 m) "non -thorough" to the tops of the beams, perpendicular to the rays. Repeat this process with four plates 2 x 6 via rays. Add another board to the end slabs to wrap them. Add the dashboard to the top of the boards to ensure the upper surface where the whirlpool will sit.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?