How can I choose the best block tiles?
After completion of the tiles or as a form of maintenance, the block tiles can be required. If the project cleaner is required after completing the project, it is usually because the tiles were reckless when laying tiles or because after paving it was too saturated with cement or lime that may leave stains. In these cases, the hydrochloric acid solution can best function as a block tiles cleaner. When used for maintenance cleaning, scratching of moss, algae and lichens and the use of a high -pressure water hose can also serve as a cleaning tile cleaner.
After completing the tiles project, the tiles area should be clean and without any stains or spilled cement. If there are stains of cement or lime, they can be cleaned using a hydrochloric acid solution. Usually the solution, also called the spirits of salt, is diluted to five to ten percent, depending on the severity of the stains.
Though the use of diluted hydro -acid chlorine can be best left to professionalsM, it can be done by an unskilled finisher. It is necessary to wear protective glasses, shoes and clothes. If the diluted acid is sprayed onto the skin, the skin must be immediately washed. The soda solution per baking should be easily accessible in case of spraying acid on the face. In addition, if it gets into the eyes, nose or mouth, immediate medical attention may be necessary.
For the use of diluted hydrochloric acid as a cleaning agent for block paving, bricks should be first wet water, for example from a garden hose. Then using a clean brush, diluted acid should be brushed through a colored area. It should only be left for a few seconds. When the colored area begins to fuck, the acid should be washed with a garden hose.
usually people are cautious when they lay tiles. As a result, a block tiles cleaner is a lot of Simpler and may vary depending on SKV typerny. For example, moss, algae and lichens tend to grow on many types of tiles such as clay bricks. Bricks can be brushed manually or scraped. In the worst cases, copper and water and water solution may be needed to stop the growth of moss, algae or lichens.
The area can also be cleaned with a high -pressure water hose. The Jetteted Action of Hase usually cleans all block paving. The hose should be set to a moderate environment and held at a low angle to prevent damage to the mortar or sand. In some cases, sand may be moved. As a result, the area may need fresh sand after using a pressure hose.