How do I create in the garden?
on the courtyard ice rink can be built relatively easily and cheap in the afternoon. Most of the courtyard skating has a wooden frame around the edge and is lined with either a large plastic insert or a sail. The garden hose can be used to fill the ice rink.
The first step in the construction of the court ice rink is the localization of the shifting plot on which the ice rink is being built. Then, using the measuring tape, spread the ice rink of the size you want and safely pound four wooden bets in the ground in the four corners of the ice rink. If you want to check how the level is the area, you straighten and stretch the diagonally via bets. Hold the level in the middle of the tense lines and let the helper adjust the line on each bet until there are linked lines on the level.
You should now measure how high outside the ground is a chain on every bet, and then subtract the lowest height of the highest height. Add 2 inches (5.1 cm) to this difference to compensate for ice thickness. Thje the amount of how tall will l be led at the lowest point of your ice rink. In addition, add approximately 3 inches (7.6 cm) to this value that allows a wooden lip above the ice, and this final amount is how wide the lumber will have to be for the limit of your ice rink.
The boards that are 8 inches (30.5 cm) or 10 inches (25.4 cm) are wide, are a good width for the ice rink boundaries. If the final sum of the rink height is less than 8 inches (30.5 cm) or 10 inches (25.4 cm), you can use these standard sizes. Any amount of more than 10 inches (25.4 cm) will require you to use more expensive and wider boards. Instead, you may want to move the ice rink to a flatter location.
Next, you must calculate the size of the plastic insert of the ice rink. The ice rink can be sealed with a liner that will have to lower the inner edge of the ice rink frame, down from the outside of the frame and tuck underneath it. To AccomModate this, you will need to add 38 inches (96.5 cm) to longerLCE and sliding size width if 8 inch (30.5 cm) wide plates are used. If 10 inches (25.4 cm) boards are used, you will need to add 46 inches (116.8 cm) to the length and width of the ice rink to get the final required insert size.
In the hardware store you will need to buy 8 inches (30.5 cm) or 10 inches (25.4 cm) wide boards that fit into your ice rink. If the correct size is not available, you can request a trade to reduce boards. Make sure you get 1 inch (2.5 cm) lumber treated with pressure for the frame. You will also need to buy a 1 -inch box (2.5 cm) with long coated screws, eight 90 degrees brackets and a plastic insert or sail. If you have to connect the boards together to create the edges of the ice rink, you will need to buy two direct holders for each joint.
at home lying boards along the perimeter of the ice rink. If the boards need to be connected to create a single edge of the ice rink, use two direct d on each jointržáky. Next, connect two corner holders 90 degrees in each corner to create a frame. Place the insert in the ice rink and best run the liner up and down on the inner and outer edges of the frame and insert it under. Earn hay, leaves or snow under any gaps in the frame so that when the insert is filled with water, the water does not pull the insert from under the frame and causes tears.
Use a garden hose to fill the ice rink (5.1 cm) of water. Depending on how cold it is, it may take several weeks for the ice to completely freeze. As soon as the LED freezes solid, your ice ice yard is ready for business.