How do I get rid of the radon using a sump?

households with basement or houses built on the board, radon problems can often be alleviated by a modified pump system. In such a perforated pipe system located under the discharge excess ground water into the sump. Radon is also collected from these tubes. A cover with an airtight seal is placed over the sump and the raised radon is bleeded through the pipe and releases into the outer air above the roof.

Radon removal using a pump pump is one of the most popular methods to reduce radon. This type of system can be equipped in households where the French or drainage system of tiles has already been installed to prevent ground waters. It is important to note that pump systems that have not been equipped for radon removal can actually release more radon into the house using exposed or incorrectly covered sumps.

The most important features of the system to remove the radon with the pump is the submersible pump firmly fitting cover.The pump cover in the sump should be made of durable material such as ABS plastic or acrylic glass. Ideally, the cover should be transparent or have a window through which the jump can be viewed. If the pump must sometimes be replaced or repaired, it is good to seal the cover with a silicone seal because it is easily removed.

The vertical tube, usually made of a 20 PVC plan, is inserted into the cover to allow the radon to ventilate the exterior of the house. Usually the vent pipe releases the radon collected in the air above the roof. Just as the cover needs airtight seal with sump sumps, the pipe should have an airtight seal with the cover. If a properly adjacent rubber seal does not create an airtight seal between the vent pipe and the hole in the envelope, any gaps can be filled.

More silicone seals.

when removing a radon with an asysty pump in a sump that was dOtherwise, it is further consideration whether the existing system has been designed to remove surface water. Some sources of surface water processed by a pit include flood water made of heavy rain or washing water from the washing machine. A sealed cover located on the pits used to remove radon would normally prevent the outflow of surface water. In order to allow the outflow of surface water, a special drain pipe can be installed through the cover, which allows the water to pass into the sump, but prevents the radon from leaking through the drain pipe into the house.

Passive and active patterns are used for systems that remove the radon using a pump pump. Active systems use a radon fan located in a vent pipe to stimulate the radon to move on the tube and out of the house. Passive systems do not have a fan, but instead depend on the natural flow of the convection air that causes warm air to rise up and out. Depending on the temperature conditions inside and outside the house apasiThe system can be a more or less effective way to get rid of radon.

Although homeowners can design and install a system that removes the radon using a pump in the sump, its professionally installed professionally can provide better results. In the US, the Environmental Protection Agency recommends that home owners contact their state Radon office for advice on how to mitigate their radon problems. This office can also provide references to qualified experts dealing with radon removal.

To ensure efficient operation, it is good to test the radon levels before and after the installation of any radon removal system. Radon levels are generally considered acceptable when they are below 4 picocury per liter (PCI/L). Even homeowners with the level of radon between 2 PCI/L and 4 PCI/L may feel cool with the radon alleviation system.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?