How do I install the luminaire accessories?
Outdoor Lighting is useful in ensuring safety and home security, as well as contributing to the pleasure of the yard, terrace and/or pool long into the night. The outdoor flood lights are an easy and cheap accessory to the atmosphere and the values of the house. It takes little time to install the luminaire on the flood and require no special expertise.
After purchase of flood light accessories, the installation site must be determined. The luminaire should be increased to ensure efficient and extensive lighting and should be placed appropriately near the ceiling electrical cabinet. Directly below the overhang or the eve of the roof, it would be an ideal place to ensure that the flood luminaire is somewhat protected from the weather. White (neutral) wires are connected together, black (hot) wires are connected together, aholé (ground) wires are connected together. Make sure the connection connection is secure. Observe the exact size of the switch on the inner wall and then trim the hole in the plaster after the outlineTon. Hunt the wire from the box to open the switch.
At this point, determine whether the luminaire on the flood should be mounted in the outer wall or on the outer wall. If on the wall, simply drill the hole with sufficient size to pass through the wire and mount the luminaire on the wall. If you mount the flood light into the wall, trim in the wall of the correct size, be careful not to damage any internal connection or pipes near the hole and insert the box. In both cases, make sure the accessories are securely connected.
Connect the incoming and outgoing wire to the inner switch. Again, attach the white wire white wires, black to black and ground. When the switches are fixed, run the outgoing wire to the flood luminaire box and then install the cover plate to the switch.
Read the manufacturer's instructions to connect the luminaire to ensure that the correct wires areattached to the correct connectors in the accessories. Once the luminaire is securely connected, seal the seam between the accessory box and the outer wall. Install the cover plate onto the accessories and screw into the flood bulbs. At this point, turn on the power supply, try the lights and adjust the light holder as needed.