How do I install French drain?

French drain is a trench for gravel designed to direct water from a low point to a piece of property. If you want to install a French drain, start by specifying where and how long the ditch should be, and then collect the necessary tools and materials. The next steps include digging and lining the ditch and finally, restoration. French outflow is usually necessary when the adjacent property has a higher altitude and the drain water collects a slope from it. The ditch for the French drain will take place parallel to the sloping slope towards the place that the water can be harmlessly directed. For example, on residential properties, the ditch often slopes towards the street, where the water -directed water can find a gutter. As an alternative, install the French drain, so the ditch slopes towards the patch of sandy soil, where water can be easily dispersed and a less likely pool is less likely.

Plan on a ditch of about 6 inches wide (15 cm) and with withThe matter deep as the water tends to penetrate the soil. Build the necessary tools and materials that include enough landscape fabric to cover the double length of the ditch, enough gravel to trim the ditch and sand to cover the gravel to the level of the surrounding soil. The tools needed to install French outflow include two wooden or metal bets, string, level, tape measurement and spade or shovel.

The placement of the ditch begins with a country in the ground at the start of the start and end point. Connect the string between bets and tighten. Next, you level the string using the level. Start digging the ditch along this string line. The ditch should bend down in the class of 1 percent; This means that if the ditch is 100 feet (30.5 meters long), it should be 1 foot (30.5 cm) at the end than the beginning. Measure the ditch separation from a balanced chain to ensure correct.

When the ditch is dug, level it with a landscape substance. Then add the gravel layer along the length of the ditch and cover JEven a landscape substance. This leaves the debris off the gravel and allows the water to penetrate the gravel and down the ditch. Cover the gravel and the cloth with sand to the level of the surrounding soil. The last step towards the installation of the French outflow is to cover the sand with a layer of compatible soda and shaping it down.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?