How can I maintain floor beams?
floor beams are horizontal supports that hold floors in your home. Once installed, they usually do not require great maintenance unless they are damaged or exposed to mold and mold. Squeaky Floors are other indications that floor beams may require some attention. If your floor bends, has a low space, has a soft place or becomes a bouncy, it is time to inspect the beams to see if the replacement or repair is necessary. In some cases, the removal of the floor and the floor may be required.
Maintenance of floor beams is usually relatively minimal, but if the mold develops on the beams, the best problem is to solve as soon as possible. The three, which are in direct contact with soil, concrete or other naturally moist materials, are most likely to become moldy, as well as floor beams, located near the water pipeline. You want to -i mold, you can mix water and vinegar or bleach in a spray bottle and with withPretty fog solutions for beams. Do not make beams; Spray the fine fog and then wipe them. Repeat this process until the form disappears.
Sometimes it is possible to visually check the floor beams without removing the floor. This is usually possible if there is a climbing area or basement under the floor. The inspection may discover a free beam, a cracked or divided beam or even a distorted support. If any of these situations appear, you will need to repair or replace the beam as soon as possible. For a free beam, it is best to find out where the support has been released to determine if it can be re -established. It may be necessary to replace a cracked beam, but can also be simply strengthened by a technique known as sister.
The sister's beam includes the provision of a new direct beam to the old, cracked. This is done by drilling holes and screwing both Together beams. It will be important to lift the floor orA cracked beam to ensure that the new beam supports the floor, so it is flat and straight. This can be done using a car connector or a bottle jack and a 4x4 piece of lumber. The same technique can be used for a warped beam. If the floor beams are damaged outside the safe repairs, they will have to be replaced.