How do I properly vent the dryer?
The best way to vent the dryer is to lower the rigid pipe from the exhaust port of the dryer to the outside. When the dryer is located in an inner location adjacent to the outer wall, which is often the case, usually includes the production of an opening in the outer wall at least 12 inches (30.48 cm) above the ground and 12 inches (30.48 cm) from external obstruction such as deck or air conditioning. The hole on the outside is equipped with a venting cap, from which the pipeline leads to the exhaust port of the dryer. If the dryer is located far from the outer walls, the pipe system leading from the dryer position to the external venting cap must be installed to facilitate the venting process. The use of rigid, smooth pipes is recommended where it is possible to reduce the accumulation of the fiber, which can lead to problems such as impaired dryer and fire. This water is removed from wet linen by evaporation and then by venting the humid hot air from the drying chamber. However, if hot, humid air can streamT into the environment around the dryer, moisture condenses and accumulates.
Exhaust leakage from a damp dryer can cause severe structural damage if unfortunate, especially if the moisture accumulates beyond the walls of the structure. Structural elements, such as wooden studs and wall plates, can absorb moisture, lose strength and endanger the integrity of the structure. Wood can develop and mold. Most houses are therefore constructed with a pipe that provides an exhaust gases to leave the structure completely. This pipe leads to the exterior of the structure and is limited to prevent either rainwater or animals from entering.
If you want to connect the dryer ventilation to the exhaust pipes built into Structuryre, a flexible pipe is available. In the US, flexible pipes are usually made of metal or plastic foil with a wire distribution of four inches (10.16 cm) in diameter and is clamped on the exhaust pipTav dryers. Flexible pipes should be cut into size and the free end will be applied to the port protruding from the exhaust pipe of the dryer. The clamps can be either elastic clamps that look like very large rubber stripes, or there may be metal rings that are firmly screwed. Make sure that the flexible pipeline is crushed, which will reduce the efficiency of the dryer and can lead to the accumulation of heat, accumulation and fire fiber.
When installing a dryer in the apartment, there may be no access to the inner pipe to suppress it. The most common way to vent the dryer in the apartment is to vent the exhaust out of the window. This is done by creating a decrease in the frame to the width of the window and 6 - 8 inches (15.24 - 20.32 cm) and installs an external dryer. The frame is installed by the opening window, setting the frame to the location and attach the flexible pipe to it. This arrangement can be left in place or decreased and stored when the dryer is not used.