How do I remove the texture of the ceiling?
It may be necessary to remove the ceiling texture, because the material often stores dust, which seems to be stuffy. Always check that the ceiling does not contain asbestos before continuing. Turn off the electricity and remove light fittings and furniture from the room. Cover the walls and floor with plastic foil and create a special texture softening solution. Scratch the texture with a joint knife before the ceiling voltage for a future image or texture. Before starting, it is important to take the ceiling sample and send it to the test laboratory. If there is asbestos in the ceiling, hire a specialized supplier who will perform work.
Assuming that the ceiling is without asbestos, start by turning off the supply of electricity in the home. This is necessary because a lot of water is used to remove the ceiling texture. Using the circuits tester, make sure the power supply is off before taking all the light fittings from the room. Remove all furniture from the room. Each electrical outlet must then be covered with pieces of plastic.Strong plastic foil should be placed on the floor and walls.
If you want to remove the texture of the ceiling, create a special solution made of ammonia, fabric and water softeners. Although the ceiling must be very wet, it is important not to overdo it. Concentrate on small areas of the ceiling and make sure no part will remain dry. Once the solution is applied, leave the ceiling texture 15 minutes before attempting.
Remove the ceiling texture with a joint knife and be careful to avoid digging too deep into the ceiling. There may be areas that are difficult to scrape. If this is the case, this area soaks thoroughly again, let it dry again and try to scrape it again. When the texture has been successfully excluded, remove all the sheet from the floor and walls. Place the fragments of sheet metal and ceiling in the garbage bag.
After extracting the texture, there may be some holes or combs in the ceiling. INYaple holes and remove all the combs using a cut pad. Use the joint compound to make the ceiling completely flat. Establish a ceiling if it is to be re -evaluated or textured.