How can I fix the wall in the basement?
The basement wall made of stone will last for many years if it is installed correctly. Since stone structures can last for thousands of years, it is likely that any problems with the basement wall will have to do with mortar joints; However, some simple maintenance can prevent long -term problems. Hydraulic cement is also a good way to fix the basement wall damage. The exterior of the wall must always be checked first and, if necessary, a steam barrier can be added to the wall. For special protection, the sealing agent should also be applied to the walls as soon as the cement has dried. When the mortar breaks down, moisture gets inside, causing the walls to deteriorate rapidly. If possible, check the walls at least once a month and perform basic maintenance in the Malta to make sure the problem will not get out of hand.
There will also be an opportunity to tension can also cause cracks in the stone that will be needed to fix the hydraulleCeme with cement. When mixing this cement, be careful not to allow you to touch the skin, because the chemicals used for its way that they can burn soft tissue. Mix the cement with gloves. When it is warm, it is ready to apply to the stone.
When fastening the basement wall, make sure that the outer side of the wall is checked first. Dug the small ditch on the base of the wall, because it will make all the stones available. Often they are hidden parts of the wall that cause the greatest difficulty. Stones that look as if to be repaired should be removed if possible. If these stones are removable, clean them with a wire brush and use hydraulic cement to return them to the place.
The basement wall, which is damp and moldy, can be repaired by a barrier of steam on the inside of the wall. This barrier will take the form of an agum leaf that is attached to the inside of the wall. Then anything the usualThe cage is used to protect the wall, is located at the top of this sheet.
stones fastened to the basement wall will take at least 30 days to fully dry. Once the cement has dried, it is necessary to add the sealant to ensure that there is no further damage. This sealant must be applied to all areas that have recently been repaired with a new mortar.