How do I replace the ax designer?
Some people, when they are confronted with a cracked or broken handles of the ax, succumb to temptation. It is a common practice to try to stick or pour the handle, but such a procedure should be avoided at all costs. Replacing the handles of the ax is simple and the alternative repair will at best be short -term and in the worst case dangerous. The ax head could easily fly and potentially lead to heavy cuts, bruises or missing fingers during use. It takes only a few minutes to replace the ax designer, which is much better than dealing with stitches or a trip to the emergency room. The simplest method of fulfilling this task is to place the upright head of the ax into the vice and tighten as much as possible. Then take a hammer and chisel and pound away to a part of the handle visible through the opening of the ax head. He was supposed to fall out in several strokes of the broken handle.
Do you want to replace the ax label, you have to make sure that the head and handle are of the same size. Take the ax with you to the hardware store and choose a good, well -fitting handle from Hickory Wood. The handle is generally sold with several wooden pads, but if the pads are absent, they can be easily made of scrap in your workshop. The handle should also have a small slot at its upper end, where a pad can be hammered. This is important, because without the subsoil, the head is released from the new handle in several strokes.
When you return to the workshop, put the ax head over the handle. With the wooden palmage, flip the ax head on the handle until it is further. If you have selected the right handle, it should be almost guaranteed or just slightly below the edge of the hole in the ax head. At this point, because you are trying to replace your hand axle permanently your pads get into the game.
Place one of the wood in the slot into the handle. Burn it in until it goes on. If part of the pad protrudes, cut it off the maloby the hands. Task complete, now you should try the ax designer by returning five or ten strokes compared to a suitable protocol. If the head seems to be a little loose, you can drive a second pad or even a nail to the top of the handle. This extends the handle even more firmly against the ax head and it should be completely safe.