How do I stop a running toilet?
You want to stop a running toilet, you must first identify the location of the problem. The running toilet is almost always caused by a drum or filling the valve, which are located inside the toilet tank. You will need to check the clown by moving up and down to see if the sound of the running water stops. If the clapper works properly, you will need to slightly lift the floating valve filling the valve to see if it prevents the water from running. If any of these components cause the toilet to run, it will be necessary to replace it. You will need to get a new valve in the hardware store before starting the task. If your toilet is equipped with a ball type filling the valve, you should consider replacing it with a float type that usually takes longer. Before replacing the valve, the reinforcement of the water supply and rinse as much water from the tank as possible. Always carefully monitor the manufacturer's instructions to avoid creating other problems.
Thetoilet can also be caused by a worn or deformed flap. This device is usually located at the bottom of the tank and opens when the toilet is rinsed to release the water stored in the tank. Although it is possible to replace the flap without off the water supply or drain the tank, the work is likely to be much easier if you do it. Most flaps have two flexible rubber ears that attach to the toilet bowl fill tube, although some models use a more complicated clamping mechanism. More expensive, plastic reinforced models usually last much longer than an ordinary type of rubber.
If your problem with the toilet running persists, check that a string connecting a flushing description with a drum is caught anywhere. To correct the problem, it will be necessary to shorten an excessively long chain that catches under the flap. If this is not the case, you should make sure that the upper part of the toilet bowl will increase above the highest water level in the tank. If the surface isAnd the water too high, you will need to adjust the filling valve float mechanism to reach the correct height in the tank. The correct water level is usually marked both on the tank and on the toilet bowl.