What are the best tips for framing in the basement?

basement framing is perhaps one of the most difficult framing, which is performed in the house, because the distance between the beams on the first floor and the basement floor may vary in the range of rooms and pipes, wires and other pipes can get in the way of clean frame tasks. In order to make the basement easier, it should start with the frame of the peripheral walls and then the frame of the inner walls on the ground. In this way, the walls can be easily lifted to the site, although the walls should be built a little short to take into account the changes in height throughout the basement. If the main variants are present, walls should be built.

The peripheral walls must be attached to both the floor and the ceiling, as well as any other type of wall. Any lumber secured in the basement floor should be treated with pressure to withstand corrosion, rot and infestation of insects, because the wood is very likely to settle in the wood. The peripheral walls should be insulated if they are basic T is being built to complete SUThe terrain for everyday use, and then plasterboard can be mounted through insulation. If there are gaps between the upper part of the wall and the beams on the first floor, it may be necessary to glitter thin pieces of wood.

The inner walls can be built in one of two ways: either the basement framing can be done by building the inner wall on the ground and lifting it to the place, or it can be done by building a stick. It is a method in which the builder provides a piece of top plate perpendicular to the beams on the first floor and the other on the ground below it, parallel to the top plate. Vertical pins can then be more precisely solved in length, because the differences in height are probably in uneven basement. Making basement framing on the ground and then raising the wall to place it takes much less time, but if the floor or ceiling beams are above the heater, the builder may encounter the problem that he will not be able to raise the wall to the place at all.

RememberAll in any pipe or connection of either hearing or inside the basement walls must be properly ensured before installing plasterboard. If there are problems after installation, it may be necessary to tear the plasterboard and other elements of framing in the basement to correct the problem. If electrical sockets are installed in framing, be sure to map the position of the terminals and all wiring before installing framing.