What are the best tips for editing the basement?
Refinification of the basement may sometimes be difficult, but there are some tips that can make work easier. For example, remove all mold and molds from the walls, floor and ceiling and install any new pipe before starting any basement. Before continuing, check, repair, repair, waterproof and insulate the basement walls. Install the moisture barrier to the basement floor and consider the double carpet to compensate for irregularity on the surface. The installation of the suspended ceiling allows in the future easier access to plumbing and electrical wiring.
Before starting the project for refining the basement, check the floor, ceiling and walls for mold or mold areas and clean them thoroughly. Install any pipe that may be needed for heating and cooling before starting work on walls or ceiling. Air supply values should be placed near the outer walls and returned ventilation openings near the inner walls to secureLO good flow of remembrance. Wrap all drain lines and cold water supply pipes to prevent condensation. It is good to install directorial electrical and communication wiring before starting the ceiling structure.
Before starting any project for refining in the basement, it is necessary to repair the inclination, cracking or decaying walls of the basement. It will also be necessary to apply a waterproof coating to the walls. The inner walls should be designed with 2 inches (5 cm) with 4 inches (10 cm) wooden pins to allow space for plumbing and electrical cabling. It is best to balance the new walls on the wall with existing beams on the upper floor to adapt to the water connection from above. The installation of sufficient insulation in the outer walls should help check the cost of heating and cooling for the new room.unfinished basements usually have an uneven floor surface. Use of a doubtThe LE layer of the carpet can help smooth the surface. The double carpet also provides additional insulation from the surface of the cold concrete below it. Be sure to wear a concrete floor with a moisture -resistant seal before laying the carpet. A thin layer of concrete can be used to balance oblique floors.
Electrical wiring, plumbing and pipes are usually found in the basement ceiling. The use of suspended ceiling allows future access to hardware located in this cavity. A type of sound material should be placed between the ceiling and the upper floor if the new room is used for noisy activities. Shower and dryers of clothing should be venting out to prevent condensation.