What are the best tips for a particular etching?

Concrete etching is a procedure used to prepare the floor before applying the coating. The etching product is used to open pores in concrete to form a rough surface for the floor color on which it can stick. Concrete can look solid to the naked eye, but it is a very porous fabric. Complete the concrete floor in the basement, warehouse or factory is a way to seal it to prevent the penetration of substances under the surface, which can potentially cause damage.

Before starting the concrete etching, the surface must be thoroughly cleaned and left to dry. Before using any products on the floor, it should be swept to clean any dust or dirt that is on the surface. Once this step is completed, any dirt, grease or mold that may be present can be used to remove a cleaning product such as Trisodium phosphate (TSP).

Be sure to read the instructions on the cleaning product packaging to find out what the safety precautions are to beInexes. Rubber shoes, gloves and safety glasses should be worn. Some cleaning products recommended for concrete will cause irritation if they come into contact with exposed skin, and covering is the safest way to use them.

Muriatic acid is a product that is traditionally used to etch concrete, but there are other substances that can achieve the same target. The product is likely to have to be diluted with water. Be sure to put the water into the scientist first and then add the product to etch concrete, unlike the start of etching. If some solutions are washed out of the bucket, it is much better to have water and a small amount of concrete leakage than a full concentration of concrete etching and a little water.

concrete etching should spread on a small floor area with a long -seated brush. After 20 minutes, the solution must be rinsed from the floor and left to dry. AfterThe splint should be examined carefully and if the texture still appears smooth, the process must be repeated until the floor is of quality similar to abrasive paper.

concrete etching should always be performed in a well -ventilated area. Anyone who works and begins to feel weak or dizziness should leave the place immediately. Medical care should be required as a preventive measure.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?