What are the best tips for the ceiling installation?

Installing the Drop ceiling can sometimes be a difficult task, but after a few simple tips it can help minimize potential problems. It is best to create a detailed sketch of the proposed ceiling layout before purchasing any materials. The ceiling should be low enough to allow electrical wiring, plumbing or recessed luminaires. To achieve the best results, the builder's level should be used often during the installation process. It is important to use enough hooks to support the frame to prevent bending the ceiling in the middle.

Installation of the Drop ceiling can cover unsightly wires and pipes or provide a layer of sound ooparding between upper and lower floors. The drop ceilings in general consist of rectangular or square panels supported by a metal stripe grid. Above the panels is usually a small emptiness that can accommodate cabling, plumbing and light accessories. Work on directorial construction projects can be demanding and correct plannIng is necessary. In view of this, the installation of a ceiling with a drop must be straight, straight and well supported. Measure the ceiling area and sketch the dimensions on a piece of graphic paper. Mark the location of all luminaires and support hooks on the sketch. This sketch will help determine the type and amount of stocks needed for the project. Keep this sketch at hand when buying supplies.

The ceiling must be low enough to suit all electric connections, water pipes and recessed luminaires. Buy any recessed lighting in advance to determine the exact will required for installation. The panels must also have enough space to install. All electric and communication cabling must be installed before the metal grid is introduced. IPLONE starting the installation of the drop of the drop must also be in place.

The level of the builder should be used during the installation of the ceiling on the ceiling to prevent the non -professiononic and unsightly finished appearance. The metal grid is partially supported by forming connected to the walls of the circuit. This formation must be perfectly at the level of all directions throughout the room. Most of the existing ceilings are not at the level and their shortcomings will usually be enlarged by the ceiling. It is best to use the level of the builder rather than rely only on measurement.

Although the individual ceiling panels are light, they can be quite heavy as a group. Correct center support is required to prevent sagging. Hooks and wires are usually used for this purpose and sufficient amounts should be installed. It is best to install these hooks at the junction in the metal support grid. Make sure the hooks are securely anchored in the frame plates under the ceiling plasterboard.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?