What are the best tips to complete the plasterboard?

As soon as the new plasterboard is hung, it is time to switch to plasterboard. Experienced Handperson can complete the middle room full of plasterboard in about two hours, while it can take a newcomer twice in that time. All that is needed is some plasterboard tape or joint tape, joint compound, ground mesh or 200-git sandpaper, plasterboard knives and top-free field. The plasterboard is a process of recording and adding a joint compound to the seams between the leaves of the plasterboard. There are many useful hints and tricks of the store that will make any domestic finishing project professionally.

The completion of plasterboard can be a bit time consuming, because it will do it correctly, it is a process of three koat and each coat should dry for 24 hours before using another coat. When the first layer of the joint compound extends along the seams of plasterboard, it should be about six inches (15.2 cm). As a result, it is best to use a knife by sixI thumbs (15.2 cm). The knife expands best if the edges are rounded, so it will not be cut into plasterboard. Then the plasterboard tape is placed through the compound to prevent the seams from cracking and hiding.

When completing plasterboard, the plasterboard tape can be either paper or glass fibers. If it is made of glass fibers, it will stick to it separately and it is relatively easy to work with. Glass fiber tape should be used with a thick, quickly dried mixture that is made of powder. Since the joint compound based on powder -based powder is used complicated, people who are new in plasterboard should stick to the mixed joint compound and use a tape with a raw paper boat. In addition, the tape should be applied as one piece and should be pushed into the compound every 12 inches (30.5 cm) to avoid slipping and wrinkling.

6ywall. It is also a suitable time to harass corners with a thin layer of compound. Paper tape is the easiest to use for corners. Simply fold the strip of paper tape in half, place it on the top of the corner joint and push it into a wet compound every 12 inches (about 30.5 cm). Finally, pull the knife down from the wall and smooth the tape. This movement leaves the tape in the corner lying flat and removes all the excess joint compound.

The second coat of the joint compound is spread slightly wider than the first coat. It should cover the first coat of the joint compounds and a tape of plasterboard to keep the seams to hide; But he would also have a feathers in plasterboard. The second coat should only be applied after the first coat has a chance to dry overnight. For this coat should be used knives with Úda plasterboard with eight inches (20.3 cm). In addition, the second coat of the joint and Doroha compounds can be applied to the nails and screws in the same way as the first coat.

Third layer of compound would meLa to be applied to be about 12 inches (30.5 cm) and should be erased to gradually mix into plasterboard. It is best if the compound is slightly watering down or if a special joint compound with surface coata is used. It can also be applied to screws, nails, seams and corners with a knife of 12 inches (30.5 cm). It is important to the edges of the wet compound of feathers until it mixes perfectly with plasterboard. Once this coat has dried, any deficiencies can be smoothed with a damp sponge or can be grinding or 220 grit.

In the final note, if you need to grind high areas such as ceilings, use a voting grinder. It is a rod with a pad at the end that holds sandpaper. Simply hold it to the ceiling and lower it along the seams on the ceiling. Follow these useful advice and plasterboard can be something that anyone can do.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?