What are the best tips for installing plumbing in the basement?

Installation of plumbing in the bathroom in the basement can be very demanding, but there are some tips that can be useful. The most important tip is to plan carefully before construction. Toilet with up is usually a suitable choice for installation under the class; Some models can also be connected to the drainage of the bathtub and sink. Try to find an ascending bathroom plumbing directly below the bath for easier connections with water lines and sewerage drains. Be sure to install additional cabling on the toilet, support the new water supply line and check all the connections before closing the walls.

When installing plumbing in the basal bathroom, careful planning is important. It is good to map the size and location of existing water lines and the overall configuration of the sewer system. The project will be much easier if the right fittings and pipes are close. Decide in advance on the types of tools needed and to have the start of work are prepared. Keep a few dičaCaps on hand to connect all the drains that are left open during the plumbing work.

Bathroom plumbing usually requires a type of wastewater ejection method that would transmit waste water to the outflow at the top. For this task is usually the best choice of toilet. This type of toilet is specially designed for use below and provides its own tank and pump. Some toilet models also allow the outflows of the washbasin and bathtub to connect to the tank and pump. Another electrical circuit will be required to operate this type of toilet.

When installing plumbing in the bathroom in the basement, it is best to find new accessories directly below the existing tub above. This location usually eliminates the need for unpleasant or difficult pipe connections. Finding a plumbing bathroom near an existing pipe also reduces the pad -based cost and time inStalace. The close proximity of the existing sewer outflow can also reduce the workload of the toilet gas system. If this location is not available, plan it forward to make sure that you can actually create a functional connection to the sewer.

All new water pipes must be properly protected and supported. Plastic pipes must be supported at 6 feet (1.8 m) intervals. Copper and galvanized pipes must be supported every 8 feet (2.4 m). Avoid installing any pipe near the inner wall surface to prevent damage to the fasteners. Be sure to check all water supply and drain connection before installing the bulletin board.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?