What are the best tips for installing plasterboard?

The basement of plasterboard is the most important part of the basement and gives the room a sense of completeness. This is not a difficult process, especially if tips such as creating wall framing are followed before inserting vertical pins. The plasterboard leaves in the basement should not be stored in the basement and should always be installed in the corner. The last sheet will need to be cut and a cockroach and mud should be used to complete the task. The unfinished basements have concrete walls, but the basement of the plasterboard cannot be connected without framing the wall. The lower and upper plates will be required, as well as vertical pins that are distributed at intervals. The distance between vertical pins depends on the size of the plasterboard leaves. Larger plasterboard projects would require immense leaves. On the other hand, only thick plasterboard leaves in the basement are just below half an inch.

After purchasing the sheets, make sure they are stacked as close as possible to the basement. Yet they should not be stored in the room where they will be zacMěšeny. This is because they will have to be moved, which is not a pleasant task.

When installing the basement of the plasterboard, never start the wall in the middle of the wall. Choose one corner of the room and start connecting the sheets. Then the power drill should be used to install plasterboard screws on boards and pins. This process should continue until the entire basement wall is covered.

It is very likely that the last sheet of plasterboard does not end perfectly in the corner. When this happens, simply trim the leaf so that it fits the last honor in the wall. If plasterboard is installed on other walls in the basement, watch exactly the same routine.

There will be a seam between each sheet and it must be covered with mud and a special cockroach. Use a small knife to apply a mud between the seams. The purpose of the mud is to fill the gaps between the seams and also allow the tape to remain stuck on the plasterboard. On the mud shouldBeing a cockroach tape and another mud layer should be placed on the tape to ensure smooth edges.

bolts that have been inserted into the basement of the plasterboard will leave dents. You should be filled with mud. When this layer of mud has dried, use sandpaper to smooth out the surface and add paint from the color when it is ready.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?