What are the best tips for installing tiles do-it-yourself?

solving work on do-it-yourself can be a challenge, but it is also a project that can complete a handyman with the right access. As with any DIY project, careful planning is the key to the tiling of the Do-it-yourself. Before postponing the first tile, it is necessary to buy and prepare supplies for the whole project. The supplies needed for this project include tiles, cleaning supplies such as brooms and scrapers, tile cutting tools, grouting currents, tiles, adhesive and safety equipment. There are many styles and types of floor tiles from which you can choose, including slate, marble and ceramics. Each of the selection of tiles has its advantages and disadvantages and the person should thoroughly explore before selecting. Measure and multiply the width of the time when the length of the room is tiled to get the size of the room in square feet (square meters). The result will be the amount of floor tiles needed to cover the space 1 foot from the tile 1 foot (0.3 m x 0.3 m). Add 10Ent of excessive value to cover the broken tiles and space for an error. In a room with 200 square feet (18.6 m 2 , for example, an excessive amount would be 20 square feet (1.86 m 2 .

Initial work on any project of tiles do-it-yourself begins with an inspection of the substrate, which should be even and without bumps and debris. Use a sealant knife or a floor scraper to clean any building material. Use a more independent compound on concrete pads to equalize all the valleys present. In plywood bed, nails or screw all high spots. Install Harbibacker® on plywood to avoid rot if leaks develop.

After the subtle is clear, perform a dry running of the pattern, creating a cross of the tiles from the center of the door and going to the farthest point of the room. Intersect this line with another passing overwith the width of the room in the center. Place these tiles without glue and use the spacers to ensure the correct spacing. Cut and piston all tiles at the ends of the run to fit the wall. Once everything is right, remove the tiles and prepare glue.

Use the Trowels to spread the glue on the floor in the cross pattern. Start at the back of the room and head to the front. When you place them, press the tiles firmly into the adhesive. Once this cross is completed, allow the tiles to dry for the recommended time. Tap the tiles with a hammer and a block of wood while they are set to continue to secure in the adhesive.

After completing the cross, start in each quadrant and develop from the center towards the wall. Distribute the adhesive using the adhesive tool. Press the tiles in the place, align them with the tiles on the cross and use the distribution. Continue to work until you have one tile from the wall. Stop the work here and let the tiles dry according to the manufacturer's instructions.

Measure the border tiles by placing the free tile on the last tile in a row. Place another free tile on this tile and enter it on a wall with a spacer. Using the edge of the highest tile, create a pencil line through the tile below it to show where to cut. These tiles should be cut and ground on the edge at the edges before placement.

The last step in any project tiles do-it-yourself is grouting. Remove the tile spacers using a pliers of deer. Mix the grout according to the manufacturer's instructions and apply with the floating material. After the recommended amount of time, wipe the excess grout from the face with a sponge. When cured, the joint should be committed to prevent dirt and mold buildup, and complete your first tile project Do-Horself.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?