What are the best tips for installing patrol fencing?

In order to install strong, direct and long -term fencing of patrols, some important tips need to be followed. The fence posts should be buried to a depth of at least 2 feet (61 cm) and wood preservatives applied to the buried section. Each fence allowance must be precisely located and completely at all directions to create a good finished product. It is best to start with corner or end columns and make sure they are sufficiently reinforced. Before installation, patrols and other components should be cut and treated to protect them from rot.

All fence columns must be buried to a minimum depth of 2 feet (61 cm) in order to adequately support the weight of the fence. Corner posts should be reinforced in both directions to prevent them to be tilted. Fencing of patrols is usually exposed to many types of weather and preventive measures against rotting wood and moderating metal hardware must be taken. The wood preservatives must beT used for below sections of each post to avoid rot. All hardware including nails, screws, curtains and latches should be made of galvanized or stainless steel.

When installing patrol fencing, always start with corner and end columns. After these posts are fixed, connect the string from one end to the other to ensure the correct alignment of the rest of the fence columns. The strength and overall appearance of the fencing of patrols depend primarily on the correct alignment of each post. Using the fence level, make sure that the posts are at all directions at the level. If the contributions are set in concrete, fold the mixture from the base to prevent water association during the rainfall.

It is good to treat all components of the fence before installing wooden preservatives to increase the life and appearance of the fencing of the demonstration. Patrols, posts and rails should bepainted or stained before it was reduced to size. Once these pieces are cropped to the correct size, cut ends should be covered to prevent moisture from entering the wood. The tops of the fence columns should be cut to a slight angle to prevent rainwater accumulation. Preliminary fence programs protect them from rot and provide a smooth base for future coatings.

If a special patrol design is planned, patrols should be cut to the correct lengths before installation. The design can easily be the predecessor by laying a part of the free plywood patrol to be measured and cut. If you want to ensure a uniform look, place a free patrol before connecting them to the fence rails. Fastening patrols with a pneumatic naiting tool can significantly shorten the time required to install patrol fencing. It is best to leave a 2 -inch (5 cm) gap between the lower part of the patrols and the ground to allow trimming and trimming the grass.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?