What are the best tips for installing plastic lawn edging?

plastic trim edging can provide an underground barrier against grass and weed for many years when it is properly installed. There are several tips that can improve the installation process. Use a good degree of plastic trim on the lawn at least 6 inches (15.2 cm) and dig a deep installation trench to prevent weeds and grass from growing under the barrier. After unpacking, face the outer edge of the curve towards the lawn and do not forget to install any connectors evenly. Install the plastic trim of the lawn almost by flushing with the ground to allow mowing to use a sufficient number of anchor bets connected at right angles.

It is usually best to buy a commercial level of plastic trim lining rather than the type of economy. High quality materials found in the commercial edge generally last longer. The border should be at least 6 inches (15.2 cm) to prevent grass and weeds from getting under the material and into the garden. A wide, deep trench should be kick -offIt before installation to suit play and anchoring. A motorized garden dump can be used to break the ground for the installation ditch.

The plastic trim of the lawn usually has a natural curve from the package into the coil. Most trim types have a V-shaped notch on the bottom. Place the plastic trim lining into the ditch with the outer curve and the V-notch towards the garden to avoid displacement caused by the earth frost. Make sure the plastic connectors are evenly distributed inside each part of the trim to avoid the future separation from the frost. Special corner connectors are available for joining edging pieces at right angles.

Properly installed plastic trim on the lawn should be slightly above the ground level. Grass edging is designed to stop grass and roots of weeds in the entrance to the garden from the ground, but has a small effect above the ground. Non -installed too high edges of mohou be damaged by lawns or motorized lawns. Anchoring of the bets should be connected every 7 feet (2.1 m) from one edge and ending on the other.

In order to properly provide trim, anchoring bets at the right angle must be installed. Cross the bets to the edge at right angles towards the lawn. To achieve this angle, it may be necessary to expand the ditch on the side of the garden. After installing the bets, postpone the moat and water the soil thoroughly to complicate it. Fill in all depressive soil areas and water again.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?