What are the best tips to replace the ceiling fan?
The first and most important tip for the replacement of the ceiling fan is to ensure that all electricity is turned off. This means going to the main controls for the house and switch off this circuit breaker switch and effectively cut off all the energy into the room in which the fan hangs. If you do not do so, this can lead to serious injuries. If it means that the room is dark when replacing the ceiling fan, keep another light source at hand, such as a flashlight or headlight. Do not work in the dark, as this can also lead to injury.
Before replacing the ceiling fan, be sure to read any instructions that were included in the new fan unit. The fan may have specific installation directions that may change the ceiling fan replacement process; The person who installs the fan should make sure they know which color wires serve. While most wires will be similarly labeled in color, it is best to check before attempting installation. If t iso Possible, Should Installation Program Remove the fan blades from the new fan and also the old fan during the installation process to facilitate the handling of the unit. It is also a good idea to remove bulbs and covers of bulbs or shades.
When removing the old fan unit, carefully trim the wires. Do not solve them too short, as these wires will need to be reused when replacing the ceiling fan with a new unit. If possible, save the wire nuts to use them again. These wire nuts firmly hold the wires together and create an electrical connection. If possible, let the assistant stand near the assistant to take the old unit and handed over the new unit, because the installation program is likely to have to stand on a ladder or chair to reach the ceiling where the fan will be installed. Give the old unit down and take the new unit.
Check the re -checku and make sure the wires are colored. If this is not the case, note which wires should be ATT.Bolech on the wires in the house. If necessary, write the purpose of each conductor on a piece of tape and fix the wire and realize that the ground wire is usually black. Attach the wires using the nuts and make sure the connection is fixed. Screw the new unit back into the ceiling; Install a few threads each screw, then go around and tighten them, so all the screws support the unit when the installation program is tightened. Turn on the power supply and check that the unit is working properly.