What are the steps to replace the faucet?
replacing faucets, either in the interior or outdoors, is a relatively easy home project. Several simple steps are needed to replace the outdoor faucet, sink or bathtub and shower commission. These steps include switching off the water at its source, removing the old faucet, preparing a new installation faucet, providing a new commission on the spot and ensuring that all pipes are properly connected.
when buying a new faucet. It is used to prepare a new installation faucet. Without it, the new faucet is likely to escape.
Whether a person replaces them in an indoor or outdoor faucet is the first step in a replacement of the faucet off the water at its source. To replace the kitchen or bathroom, the valves are located under the sink. For outdoor faucets, the valve is right next to the faucet on the pipe stem. There is sometimes a panel for access to Valves at the bath or shower. In older homes, it could be necessary for water to be closed through the main valve next to the water meter.
Outdoor faucet replacement is usually the simplest and requires the use of a large key, a small monkey key or a few locking pliers. When one unscrews the faucet, there should be not too much pressure down on the pipe. The tube should be held by one -handed surface while being twisted. Any corrosion should be cleaned from the pipeline and after being clean and dry, the plumbing tape should be wrapped around the fibers twice or three times. After installing a new faucet, you should make sure that the washing machine on the new faucet is well seated.
There are two tubes for the sink of the faucet, one for hot water and one for the cold. The hoses are sometimes attached to the pipe with a screw terminal, but usually has an ITS hoses its own side dish. After the hose is unscrewed from the pipeline, there are two screws that hold the faucet set to the counter, and they should be unscrewed to remove the entireFAUCET lineup. All pipe threads should be cleaned and packed with plumbing tape. A small rubber cement around a large rubber seal, which fits under the new disc, prevents any leakage to the counter, but should not be glued to the counter.
The bath and shower faucet exchange are more difficult and can take several hours. The workspace is more limited and all accessories are separate. The steps are generally the same as replacing an outdoor faucet or sink, but there is more work and gaining access to the pipes can be difficult.