What are gramophone belts?
repeated tables are necessary for operating turntables controlled by a belt. The band controlled by the belt uses the motor to connect the engine and turn the plate or record the playing surface. The surface Belty is made of rubber and the manufacturer differs in width and length. However, not all turntables require repeated belts. Some turntables are powered by an engine or “direct drive” and a small engine directly turns the plate.
The buyers of the gramophones controlled by the belt are often cheaper than direct drive turntables because they allow the use of a cheaper engine. Loading materials controlled by a belt and direct drive have their lovers, and each type exists by advantages and disadvantages. It is assumed that repeated belts work more quiet than the engines of direct drive tables and provide an excellent listening experience for many listeners. Therefore, many audiophiles consider gramophones controlled by the belt to be the best for occasional listening. Direct turntable is often used by DJs because the direction of rotation of the record can be changed rapidly. Direct direct -drive converters are often more robust than their belt controlled.
The shortage of the repeated belts is that they eventually fail and need to be replaced. Foldy use can also become fragile or worn and lead to lower sound quality from your record player. Replacing or sometimes adjusting the old belt can improve sound quality. In local stores, it may be difficult to find spare repeated belts, but are widely available on the Internet and in most models it is easy to replace it. If you want to find the replacement, measure the length and width of the swivel table belt, and note the brand number and model of your turnover.
You want to replace belts, follow these simple instructions. First take off the rubber or felt pad from the plate. This is where you would normally put a record that you are going to play. You will see several access windows on a plate that you can use to zthe plate of the plate from the swivel table. There may be an internal clip that you will need to release. While the plate is off, use the fabric without a fiber to dust the inside of the rotary table. Visually find the engine and pulley where the belt is attached. Then place the new belt around the inner edge of the underside of the plate, it will fit freely. Replace the plate and achieve an access window near the pulley and connect the belt to the engine.