What is the finishing spoon?
The finishing bed is a tool used for smooth mortar or plaster. The tool has a very flat blade to which the curved handle is attached. This blade is usually rectangular with very pointed corners and edges that are somewhat sharp. It is used firmly by placing the blade on the surface to be smoothed, and then a moving spoon in a straight line.
Most of the time has an aluminum or steel blade finish. The description of this tool can be either plastic or metal, and is usually connected by a metal rod containing rivets or screws. This helps keep the handle firmly attached, even if the worker uses a device on a very thick material.
The finishing screed blade is very flat on all sides. All corners and edges of this section are very straight and even. Although this tool is not designed for cutting, the edges of the blade can sometimes be very sharp. People should take care not to come into contact with them when they work.
Most of the model have a handle that is slightly zakŘeváná naře. The lower part of the handle is connected to the metal rod at the top of the blade. This part of the handle can be equal or slightly angle. On both sides of the upper part of the handle could be a padded part for further comfort.
The finishing bed can come in many different sizes. The standard width is about 10 inches (25.4 cm), with a length between 30 and 50 inches (76.2 to 127 cm). Small Trowel can be only 7.5 inches wide (19.05 cm) with a length of about 30.5 inches (77.47 cm). This type can be useful in completing small surfaces or to achieve tight areas.
For the use of a finishing spoon, the worker should first grasp the tool while holding the blade flat against the surface to be smooth. It can then work either back and forth or directly up and down. When the blade becomes a fastened material, it can either be erased by a damp cloth or spraying clean. After finishingThe work should not be in Malta or plaster no grooves or stripes and the material should be vertically even. If the imperfections remain, the user can re -smooth the product if the material had no chance to harden.