What is the hot water thermostat?

Thermostat of hot water is a mechanical device that controls the water temperature in the hot water heater. The device contains a sensor that detects the water temperature and turns on or off. Hot water heaters are equipped with thermostats installed from the factory. On the outside of the water heater is mounted the thermoste unit of the hot water and can be replaced if it is defective.

Typical water heaters use gas or electricity as a source of energy to heat water and both types are equipped with a thermostat of hot water. Both types of thermostats perform a similar function, but are mounted differently. The thermostat gas hot water is more complex and difficult to replace. The electrical hot water thermostat is relatively easy to replace and cheap. The owner of the house on units equipped with traditional voltage voltages can be replaced. The services of a qualified supplier may be suitable for water heaters equipped with a microprocessor. Replacement thermostats can be purchased for individual, upper or lower elements. TheseThe units are available online and from home improvement shops. The electrical thermostat of the hot water is mounted to the body of the water heater, so that the unit is not necessary. Before replacement or modification, the unit power should be off the circuit breaker box.

water heater is usually on a reserved circuit breaker. If you want to replace the thermostat, you should remove the upper and lower access panels and remove the insulation to detect the thermostat. The high -temperature limit switch has a reset button and is usually the upper panel. The thermostat is calibrated in stages or with high, medium and low settings.

One should disconnect the wires from the terminals on the thermostat and record the connection position. The unit should be unscrewed from the mounting block. The same type of unit or universal hot water thermostat should be used as a replacement. One should re -mount the wires in the same positions and pull the insulation. The cover plates should be connected and the circuit breaker should be converted to the "ON" position.

The replacement of the thermostat on the gas water heater is slightly more difficult. The owner of the house can be replaced, but a qualified plumber can be a better choice. For one, remove the hot water thermostat from the gas unit must be drained from the heating because the thermostat protrudes into the unit. The thermostat should be turned off on the gas control unit and the gas shut -off valve should be converted to the "OFF" position.

One should carefully disconnect the lines running from the control unit to the unity of the burner and then remove the Union and the gas tube leading to the control unit. The control unit/thermostat should be unscrewed from the water heater. The new unit should be installed using the correct piping doping designed for gas installation. The same pipe daggers should be used to replace the pipe. Turning the gas should be converted to the "ON" position and one should test soap water leaks.

heatedThe water ívač should then be illuminated according to the factory specifications. Finally, the hot water thermostat should be set to the desired water temperature. The water temperature on gaseous and electrical units should be set sufficiently high to provide enough hot water. Energy saving can also be a reflection.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?