What is the cherry veneer?
Cherry Veneer is a product derived from a cherry tree and is used to create furniture, floors and doors. The veneer is a wooden leaf, as thin as 1/40 inches (0.635 mm), which is often associated with plywood or other cheap wooden cores. By using veneer, you can enjoy the appearance of the cherry without high cost of solid wood. The use of veneer also helps to preserve natural resources. It is a relatively expensive material, especially compared to birch or oak veneers. Cherry Veneer is one of the simplest forests to work with, and there is prices for its smooth grain formula and rich colors. The cherry veneer grain formula depends on several factors, including how the wood was cut and the veneer leaves were compared. With ordinary slicing, leaf veneer are cut parallel to the line center of the protocol, leading to a smooth pattern with the least amount of grain variations. Using a rotary section, the protocol turns on the lathe because the slices are cut from the perimeter. It works best for birch or oak kvůland patterns of grain of these forests.
with a quarterly section is the first quarterly protocol, then the slices are cut in the radial direction towards the center of the protocol. This is the most popular cut for the icing because it emphasizes the "spots" of the "lightning" pattern in the grain. Cut cutting is similar to a quarter cutting, but reduces the amount of stains in the pattern by lowering the quarter at an angle.
Once the cherry veneer is removed from the protocol, the veneer leaves are stacked in the order they were cut. The sheets are then connected in a process known as "matching" where the type of desired appearance determines the method of Sheet should be determined. One of the most common techniques is a book match where every additional leaf of veneer turns in and creates a mirror effect. However, when working with the icing with Charry or Rift, a more symmetrical balance or compliance with the center balance may be required. This includes manual selection of veneer sheets and correspondingIt is to create a pleasant, even effect when they joined.
After the cherry veneer has been cut and compared, it is delivered to distributors. It is often supplied raw, where the leaves are held in the order that have been cut. In this way, the buyer can use a veneer to create their own cherry furniture or door. Veneer can also be supported by paper and create leaves of pre -matched cherry veneer. Many buyers consider this material easier to work, especially when packing a curved surface as a column or a rounded piece of furniture.