How can I repair water damaged BlackBerry®?
The first step to repair the water damaged water BlackBerry® is to remove the battery. Whatever you do to treat your device back to health, it is necessary to let it turn it on or off until it is completely dry. After the battery is outdoors, you can also remove the subscriber identity cards (SIM) and Micro Secure Digital (SD) if your model has them. You can then use compressed air or hair dryer to dry the device as best you can. You can then place the water damaged BlackBerry® near an indirect heat source or in a sealed container with silica gel or rice. Putting or turning on a wet device is a good way to destroy different electronic components, so it is a good idea to immediately remove the battery. In addition, you may want to stay away from fabrics such as acetone, as the liquid crystal display (LCD) and other components can be found. Alcohol friction can be useful under certain limited circumstances as if the circuits were contaminated with soda, saltyFor water or similar liquids, even if much attention must be paid to not cause further damage.
If you have access to clean compressed air, you can use it to throw away most of the water from the device. Note that compressed air available at service stations can be contaminated with oil unless the compressor is properly maintained and canned air can express harmful chemicals unless the CAN is held perfectly at the level. Any of these contaminants can more harm your already damaged BlackBerry® water. Another option is a hair dryer, although it should be set to low or not, heat, because too hot air could potentially damage electronic components further.
Once you have removed as much water as possible two common ways to evaporate or absorb the rest. If you have a computer monitor, a cable box or other similar devices, you canSet the water damaged BlackBerry® near these heat sources. If you do, it is important to monitor the device so that it is not allowed to be too hot. The second option is to place the device in a closed container with either unread rice or silica gel. One of these materials can be able to absorb the part of the remaining liquid that has remained in your Waterproof BlackBerry®.
The only other thing needed to repair your water damaged Blackberry® is patience. Re -inserting the battery and turning on the device, before it is fully dry, can cause irreparable damage, so it is good to let it dry as long as possible. This could be anywhere from a few hours to one day, depending on how the wet device was and how good the work you did.