What is a diode rod?

The

diode bar is a bank of semiconductive laser emitters combined with the circuits of the driver and the optics to form a diode laser module. These units resemble metal transistors. Lasers are arranged in a number of wide range emitters or partial elements of 10 to 20 thin strips. They usually accompany the monitor photo chip to check the performance feedback. These modules operate in technologies from disks for home drives and printers to laser indicators. Higher powered diode rods provide laser light for applications such as laser surgery and industrial surface treatment of materials. Can draw dozens of watts of output power; Their wavelengths decrease between 780 and 860 nanometers (Nm) and 940 to 980 nm, as typical for pumping lasers in solid state in optical networks. Lasers with a high power of more than 100 watts (W) can be created vertically by stacking diodes. These lass are highly efficient, energetic and clear; This makes them suitable for many applications across industriesi.

Common lasers produced by diode bar modules can be found in computer discs and audio disc players. These rays fall near the infrared part of the electromagnetic spectrum at 780 nm. Such lasers are set out at approximately five million (MW), but are collimated by optics that reduce their power to 0.3 to 1mW. The infrared (IR) laser diodes of computer optical drives are set up up to 30 MW. Well -known dark red lasers created by the oldest visible laser diodes operated by approximately 670 nm, in the range of visible spectrum.

colimation refers to the focus of disorganized light rays into the parallel beam. In electronics, this could be achieved using a plastic lens with one element, which is a convex lens with a short focal length. Diode laser modules use theasfeir lenses; This means they are not balls.

in OP networksTical fibers are made as a fiber component. This allows for greater use of the output and the ability to distance the module and the cooling system from the laser hot point, such as a laser head with a diode. It is usually associated with one and multimod fibers or is tied to a single fiber per emitter.

Standard and own wavelengths are possible with these components. Diode bar units are available in a series of stripe and bar width and cavity lengths. Safety measures are guaranteed, especially in collimated beams, as they can cause vision damage. Lasers with an output of more than 3 to 5 MW or wavelengths near a visible spectrum are the greatest danger. The beams should be calibrated indirectly using a tester, a laser power meter, an IR detector or even a reflecting card.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?