What is an external socket?

The external socket is usually an electrical outlet installed outdoors that need to be protected from elements. The term is widely used in England; The same device in the US is called an outdoor socket or exterior. The drawers themselves do not differ from those installed inside houses and other structures. The difference between internal and external sockets is the nature of the connection to the energy source. All electrical work should be carried out in accordance with local and national electrical and building regulations, which often require permission and control of competitive work. Similarly, all consumables and equipment should be compatible with the code.

The two most important elements of compliance with the code are the type of cable used and the type of output. Most electric codes require any cable to run outdoors for use of external use, such as underground feed (UF). In the behavior of remote buildings such as garages or shelters, the UF cable can be buried directly in the ground, at least 18 ”(45.72 cm)This is usually required in outdoor work unless the circuit is protected by a circuit unless the circuit is protected by the GFCI circuit.

.

.

The reality of electricity from the inside to the outside of the structure is probably the biggest challenge facing the household by installing an external socket. Some households provide external energy using extension cables or electrical cable through windows, doors or other holes such as exhaust exhaust gases. It is a dangerous, illegal and impractical approach. A hole must be drilled in the outer wall to pass the electrical cable. An external intersection should be mounted to the outer wall, with the back of the knockout directly above the opening.

External connecting boxes are specially built for outdoor use, with special attention to ensuring that the water cannot penetrate. Have holes similar to knockout holes in the inner connecting boxes but are youBasted screws with plastic plugs that provide waterproof seals of any unused hole. The cable enters the outer connecting box only through the pipe, which is connected to the waterproof seal. The cover plates are mounted through the Diecut seal, which also create a waterproof seal, and the spring cap with rubber seals automatically cover each external socket.

Cable power from the interior of the structure will be evaluated for use of external use. It is secured at the intersection as in internal work and seams, where the boxes touch the outer wall, should be sealed with a silicon seal to prevent moisture from entering. The outdoor connection in some respects is easier than inside the wiring because no walls are connected. Some jurisdictions allow you to operate the UF cable along the outer wall is supported every 36 inches (91.5 cm). However, many jurisdictions require that the outer cable be triggered inside or buried.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?