What is the difference between the line conditioner and the protector of the overvoltage?

The difference between a line conditioner and an overvoltage protector usually consists in their intended function. The guide conditioner takes strength and modifies it based on the requirements of the machine to which it is connected. Overvoltage protectors will not change the strength that flows through it if this force does not exceed a certain amount. When the power supply exceeds the set amount, it blocks it in the passage. It is not uncommon for these two devices to be in the same unit.

Both line conditioners and overvoltage suppression are important parts of modern electronics. It protects the internal functioning of the device, often without even realizing it. Many people go the next step towards placing other protective devices between wall sockets and electronic products. Some systems require very tight or non -standard performance tolerances and use lines conditioners to change strength to meet their requirements. They are also a running method of extending the lifetime of electrical equipment because properly created electricity creates less OpotŘebení on the inner parts of the device. Most of the electrical systems have line -up conditioners built into them, usually as very small devices that are integrated directly into the inner plate. They monitor the voltage moving across the board and maintain it within a specific tolerance. Larger line conditioners are available, from small in peak surge protectors to industrial units of car sizes connected to factory machines.

Surge protectors prevent energy overload. When the force exceeds a certain amount, it prevents it from passing. Different overvoltage protectors do this in different ways, but the most common method is to create an abbreviation on the ground conductor.

This connection with the ground only occurs when the power is prevented by a uniform; Otherwise, the unit would constantly waste electricity. If the surge protector is incorrectly connected, for example via two or three -chamberHo adapter, he can't send energy to the ground. In this case, the surgeon may overload and ignite or even send the overvoltage to the connected device.

It is not uncommon for the conditioner of the guide and the surgeon to be placed in the same unit. Because these systems work to hand over tension, it makes sense to put them together. Some systems have a very advanced line conditioner that acts as a surge protector if necessary; This is common in battery backup systems.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?