What is a Water Ionizer?
The ion generator is a method that uses a high-voltage transformer to boost the power frequency voltage to the required voltage to generate negative ions, release them into the surrounding air, purify the air, and improve people's living environment. This kind of equipment for artificially generating negative air ions is called an air negative ion generator or negative ion generator, which is referred to as an ion generator for short.
Ionizer
- The ion generator is a method that uses a high-voltage transformer to boost the power frequency voltage to the required voltage to generate negative ions, release them into the surrounding air, purify the air, and improve people's living environment. Artificially produced
- Ecological negative ion generation chip technology
- The main role of the negative ion generator:
- (1) Manufacturing active oxygen:
- The ion generator listed in the table below has the following characteristics:
- -Suitable for global voltage input.
- -Before leaving the factory, the voltage output can be adjusted according to the characteristics of the matched ion generator to achieve the best matching performance.
- -You can also use the environment in the field and fine-tune the output to achieve the best results.
- -Error detection circuit to ensure safe use.
- Table: Available ion generators and maximum allowable numbers
|
|
|
|
| |
|
|
|
|
| |
|
| |
|
| |
|
|
|
|
|
|
- Note: If used with an inappropriate ion generator, it will cause unpredictable damage and damage to the power
- Input: 90 240VAC, 50 / 60Hz, Max 40VA
- Nazi Fullerene Anion Releaser
- AC output: 3,400 4,000 V (factory setting)
- DC Bias: 0 700 V (field adjustable)
- Output current: 5mA max.
- Insulation resistance: between primary coil, core and case, minimum 10 Mohm (at 500VDC)
- Operating environment: 0 40 deg C, RH 20-85%
- Degree change: Built-in transformer: 65 deg C
- Housing: 40 deg C max.
- Error detection: When there is a problem with the high voltage output, cut off the input power
- Problem judgment: output is too low: 3,000V +/- 5% when DC bias is 0V
- Output too high: 4,400V +/- 5% when DC bias is 0V
- Response time: 100 200 ms +/- 20% (adjustable)
- External switch connection: Circuit breaker: 125VAC, 0.2A or 30VDC, 1A
- Internal structure of anion converter
- Reset: Turn off the power and then turn it on again after 3 seconds
- Output port: 2 x Polycarbonate High Voltage Terminals
- Volume / Weight: 15.7 x 16.5 x 11.5 cm / 4.3 kg
- Appearance: Metal Sheet (1.2mm) in white color Power cord: 1.8 m
- - switch
- -Indicator light (blue)
- -Ground terminal