What is Jumper BIOS?
Basic jumper input/output system (BIOS) is a small device used to configure specific settings on the BIOS computer. Jumper is connected to a range of metal pins on a computer motherboard that completes the electrical circuit and configures the appropriate settings. BIOS groups can be used in the case of a lost BIOS password or damaged BIOS update. This software loads the operating system and controls some hardware settings. BIOS can be updated and most BIOS software types can be protected by password.
Bios Jumper can be found inside most computers. The jumper itself is made of conductive material such as metal, and is usually covered with a plastic coating. During normal operations, the panel remains in its position in the factory.
If the user has forgotten the BIOS password, Jumper BIOS can be used to reset it. The physical location of the jumper varies depending on the motherboard, but is usually located near a flat round battery. It is best for users to refer to the motherboard manualRO place because often will include a useful picture or diagram.
In order to reset the BIOS, the jumper must be removed from its normal position and placed in resetting or clear position. Some motherboards mark the position. Common labels include CLR for "Clear", PWRD for "password", resetting or some combination of these phrases. The motherboard guide will often contain images or schemes of different jumper positions.
The small size of the Jumper BIOS means it can be difficult to manipulate. Many users prefer to use pills or tweezers to move the jumper. The computer should always be turned off and disconnected when it works with internal components.
and BIOS Jumper AltaCže can have a position for something called BIOS recovery mode. This is useful if the update has caused the computer not to run. In some cases this requires regenerative software loaded on a floppy disk, compactdisk or flash drive.
Some motherboards also implement safety functions to prevent malicious software in BIOS modification. These functions require Jumper BIOS to be set to another position before the BIOS update. After the update application, the jumper must be moved back to its original position.