How can I complete the glass fiber?
try to get a high gloss on the glass fiber product may seem like hard work. The completion of glass fibers is in fact a task that will require great effort, but the steps necessary to complete the laminate are quite simple. Here is a list of materials that are suitable during any project for glass fiber finish and some basic instructions on how to proceed.
If you want to finish the glass fiber, make sure you have a lot of sanding paper on hand. You will need a series of cruelty, starting with low gravel paper and going to a high level of pumping paper. Slobra with grinding is a necessity before you can think about applying the surface to the surface. The exterior of the glass fibers must be perfectly smooth to achieve the appearance you want. To achieve the best results, do not try to grind only by hand. Your fingers will naturally apply different layers of pressure when grinding. The use of the sand block will exert even pressure and youto form a smoother surface.
Next, you will need Putty filler to take care of any indentation that you cannot remove. You may want to consider pre -grinding and then lay the filling sealant coat on the surface. This will help fill any indentation while grinding on a smooth surface. Only in case there are some small pits or valleys that are not filled with a filling sealant have some point sealant at hand. Simply apply a small amount of finger and then fonts that sealant to the surface of the glass fiber surface.
The next task in the task of finishing the glass fiber is to apply the coating. It is good to use a thick polyester primer that contains some epoxy in the mixture. This ensures that the coat properly holds the glass fiber glass. You can also consider mixing a small amount of colored coat into the primer. Adding a color from herOPERIASIER complete the glass fiber with only one top coat instead of two.
Finally, to complete the glass fiber, you will need the final coat of colors. The use of a spray gun will provide a smoother coat than the use of syringes in a can. You will also have more control at the angle and color distribution as it goes on a glass fiber. When spraying on the color, make sure you stay the same distance from the glass fibers. Allow one coat to dry slightly before you start. Do not be discouraged if one coat does not do this work. It is likely that you will not need more than two if grinding and filling have been done correctly.
The last step in any project to complete the glass fibers is what is called a clear coat. This should be applied no more than a day after the painting is completed. Before applying a clear coat, make sure there is no dust or residues on the newly painted glass slope. Spray on one coat and leave itto dry for a short time. Add at least one coat. Depending on the Clear Coat brand you use, two layers should be enough to pack your project.
With this method, you can complete the glass fiber components of all types, from the lawn and terrace furniture to the fenders of cars. It is good to finish the pieces of glass fibers with fillers, primers and colors that are made by the same manufacturer. In this way, you can be sure that there will be no chemical interaction that could internally damage completion. Do not forget that working on the completion of glass fibers is one that requires patience and a lot of time, but the results can stand over.