What Are Booster Pumps?

Booster pump, as its name implies, is a pump used for boosting pressure. It is mainly used for boosting water heaters, low water pressure in high-rise buildings, saunas, baths, and other pressurization. , Booster for reverse osmosis water purifier and so on.

Booster pump

Booster pump, as its name implies, is a pump used for boosting pressure.

Fill the booster pump with liquid first, then start

"Negative pressure pump" and "positive pressure pump" are mainly distinguished from functions and main purposes. The "negative pressure pump" is mainly used in places where vacuum (negative pressure) is required, such as: pumping, gas analysis,

Tap water booster pump must be installed horizontally or vertically as shown in the "Installation Method" display. The direction of water flow should be the same as the direction of the arrow on the pump body. For ease of use and maintenance, a valve should be installed on the pump inlet line. When the pumped liquid level is lower than the upper end face of the pump impeller or the shaft of the pump, the pump should be installed with a check valve. The outlet end is connected with a tee for water introduction. Tighten the plug. The piping connection should be tight, especially the water inlet pipeline should not leak air, otherwise the pump head will be reduced or the water will not be pumped. Before the pump cavity is filled with water, do not rotate continuously for a long time to avoid damaging the seals.

The motor coil is equipped with a safety protector. When the pump fails or fails to pump water, which causes the motor to rise above the specified value, it can automatically open the circuit. The faulty motor is to be removed

To measure the performance of the pump, the power is not important, but the efficiency of the unit. In the case of the same head and the same flow, the power is small and the efficiency is high, that is, the performance is good. Water pumps are labeled with the highest head flow and rated head flow. Most pumps on the market are labeled with the highest head flow. Some

The name of booster pump is the pump that is installed on the pipeline to boost the pressure. It is a special name for many pumps. Generally speaking, the pipeline booster pump refers to a pump installed on a pipeline to convey liquid, and is not limited to a certain type or form of pump. It can be vertical or horizontal, such as a vertical multistage centrifugal pump. Horizontal multistage centrifugal pumps, vertical single stage centrifugal pumps, horizontal single stage centrifugal pumps, self-priming centrifugal pumps, etc. can all be called pipeline booster pumps. Generally speaking, the pipeline booster pump in the industry refers to a pump with a pipeline structure, which can be directly connected in series like a pipeline.

Since the booster pump is another name for a pump, its selection also follows the selection of a centrifugal pump. The parameters to be noted are nothing more than flow, head, material, and specific gravity of the medium. What we usually refer to as the pump flow rate and head refers to its rated flow rate and rated head. The so-called rated flow rate and rated head refers to the situation where the pump inlet and outlet are fully open and working at the power frequency (50Hz). The amount of water pumped and the height to which it can be pumped. The rated head corresponding to the rated flow of the pump is called the optimal working point of the pump. This working point is the most efficient working point of the pump. Therefore, when choosing the pump, try to choose the pump with the best operating point parameters. This will not only bring out the best potential of the pump, but also increase the service life of the pump.