What are positive pumps?

Positive displacement pumps move by liquid by creating pressure imbalances in an enclosed environment. This imbalance causes the liquid to move from one place to another to try to balance the pressure. This type of pump is only used with liquids and is a simple method to create a constant flow.

There are two cavities in the pumping positive displacement: the expanding suction cavity and the decreasing discharge cavity. At the beginning of the cycle, the suction cavity is less than the drain cavity. As the fluid flows, the suction side expands. This changes the pressure inside the pump that causes the liquid to flow into the drain cavity to compensate for the internal pressure. When the liquid moves, the suction cavity decreases and re -creates the original pressure imbalance.

There is no closing head in this type of pump, so it is necessary to ensure that relief or safety valve is functional. Correct use of this valve ensures that the appropriate foretner SSURE is maintainedoverstated within the pump system. If the drain cavity is closed, but the pump works, a line or pipe that the liquid moves can burst. This would be caused by an increasing amount of liquid pushed towards the drain cavity. If the line bursts, all the liquid that tried to move to the drain cavity would spill the pump and create a big mess.

There are two main classes of positive pressure pumps: reciproce and spiral roots. The surplus pump is also known as a plunger or a membrane pump. The piston pump has a cylinder head where the intake and drain cavities are located. With the form of a plunge of the plunger, it pushes the liquid out. The suction lift pulls the piston and opens the suction cavity and pulls the liquid into the cylinder.

The

pump pump generates a lot of unnecessary energy to the end of the pumping cycle. The membrane pump uses the same pressure piston movementto move the membrane inside the pump itself. This type of pump is used for hazardous materials because the membrane material is used to retain the liquid from the operator.

The hellic root pump is also known as the Wendelkolben pump. It is used in situations where the liquid has a high viscosity and smoother pumping actions are needed. These positive displacement pumps use two rectangular hellic twisted rotors to create a low pulsation rate. At the entrances on the suction and discharge, the triangular sealing line is used to ensure continuous, even flow.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?