What is the head?
The housing head is part of a well of oil or gas drilling. This hole represents a part of a well that is visible above the ground, and the head of the case sits on the base of this device. The housing heads rest at the top of the main operating components of the well, including dripping or guide pipes. In general, they are determined on the spot, along with the rest of the well. Most of the moving components in the Well system are located underground under the head of the case. It can be designed from galvanized steel or special alloys to increase corrosion resistance in often extreme conditions occurring in the oil field. This device is welded or screwed to the drive below and the creation of a stable and permanent bond. Each of these steel flanges must be designed to suit the extreme level of pressure and temperature range, which are common in drilling oil and gas.
The head of the cover on the Adobra is primarily used to place a series of preventor units (BOP). Many holes includeE Two types of BOP units, including RAM and ring models. Blowout Preventers are critical for the safety and performance of the well. These special valves are equipped with an extremely high pressure level and are designed to look for pressure changes themselves. Each of these valves can be attached or welded to the housing head.
The housing heads also store various surface equipment needed to control and control drilling operations. This may include special monitors or panels that measure the pressure, temperature and depth of drilling in the hole. It also includes pressure control devices, including prevention and related controllers. By serving as a temporary point between subsurface and above -ground components, the head of the case often acts as a legacy of bmezi by these two areas to hang equipment, wires and sensors.
Depending on the application, this device can also serve as a special baseThe assembly of controls and valves used to operate the well. This assembly is often referred to as a Christmas tree because of its similarity to a decorated holiday tree, with pipes and valves spread at many different angles. The Christmas tree is used to control oil or gas flow to a nearby processing plant and can also be used to turn off the well when the production has stopped or stopped.