What is an insulation set for a flange?
The insulation set of the flange consists of a flange, screws and insulating sleeves used to install the leak -resistant flange. The insulating sleeves used in the insulation set of the flange are made of high density polyethylene plastic, which prevents electric charge from different metals causing corrosion and eventually weakens and breaks the flange screw. Instead of the conventional system of nuts and screws, the insulating set of flange with a washing machine and walnut at each end of the flange joint uses. In addition, a chemical reaction is often created that causes metal deterioration when connected. In a typical pipe, this weakness is a flange. Corrosion is commonly responsible for breaking and failure of flange screws, where two different metals, such as valves, meters and inline heaters are connected. Insis -insulating insulation set of flange, the union of both metals is often more trustworthy.
by key components in the insulating set ofRuby are polyethylene insulating housing and mounting pin. The insulating sleeve is inserted into the holes for the flange screws using one insulator on each side of the flange. As a result, two insulators on the hole opening are inserted into the flange. The mounting pin is then inserted into the insulating sleeves until the thread at each end of the pin is visible outside the flange. At each end there is a slipped flat, steel pad and at each end of the pin is stretched the nut and tightened.
By tightening the nut at each end of the pin, connecting the insulating set of the flange becomes much stronger than the typical connection of the matrix and screw type. When the matrix is tightened to the screw in the traditional way, all clamping force is to be applied to a single set of fibers on the screw. When a double end is used, for example in the flange insulation set, the clamping force is evenly distributed between the fibers at each end of the pin and inside the two nuts. Shame, suspended from a metal flange inside the sleeves similar to plastics, is protected and isolated from anyElectric charge and corrosion. This creates a flange connection that will not corrode or fail due to the chemical reaction between two different metals.