What is it and the thickness of Holán?
The thickness of the plater is a tool for processing wood designed to produce plates of constant thickness and perfectly flat surfaces. It is a table tool, which means it is a non -transferable device mounted on the floor with a working mechanism mounted on an adjustable flat work surface or table. Hotoner thickness consists of four basic components: height adjustable table, cutting head perfectly perpendicular to the table, set of in-Feed cylinders and set of out-Feed rollers. The machine works automatically by feeding the board over the table, thereby shading the nominal amount of material from it when it passes through the cutting head. If necessary, the board is then inverted and the process is repeated which produces a product that is flat and the same thickness over its entire surface.Ploché surfaces. The thickness of Holán, often called cash, is such a machine. This machine is equipped with a wide cylindrical cutting head with two or more longitudinal cutting blades. The cutting head is located higher and perfectly perpendicular to a flat workingA table that can be adjusted to ensure different thickness of the finished board. Two sets of rollers, one in feeding and one set out-Feed, automatically feed the plate over the table and under the cutting head at both ends of the table.
When the board passes under the cutting head, the cutting head is cut off a certain amount of material. Due to the flat table, perpendicular orientation of the cutter and the pressure of the cutting pressure, the plate during the cutting pass maintained flat. Once the cut is completed, the rotary plate can be cut the opposite side if necessary. This creates a plate that is exactly the same thickness across your face with perfectly flat surfaces.
The thickness of Hare works best if one side of the board is relatively flat and uniform. This generally allows you to complete the board in one passage. If the plate is warped, Jonowter or an energy plane should first go through to reduce the gadget. If soIt does not, the pressure of the cutting head on the thickness of the Holán simply pushes the plate during the pass, only to regain the curvature when leaving the machine. Hotoner thickness machines are relatively dangerous if they are used incorrectly; Operators should always follow standard operating procedures and, in all circumstances, wear hands, eyes and ear protection.