What is Riser Clamp?

The riser switch is a device used to support vertical pipes, pipes and pipes in various areas of the structure by transferring the weight of the pipe to the terminal and the building. The riser switch is designed in two halves. Each half has an arm that reaches from each side and a semicircular area in the middle to fit around the pipe and form a whole circle when they connect half. The sides of the terminals have been divided and are slipped around the pipe before the screws that are tightened with the key to hold the pipe on the spot by friction. This allows the clamp to be slipped apart and around the pipe. Once the climbing terminal is in place, the screw is tightened to the site. These clamps also have an serrated walnut walnut attached to the screw, so the screw can be tightened in place without needing a key for each side. Some riser clamps do not have an open AMUSI slot to be fully expanded to make around the pipe. After the location, the screw slipped into the hole and the nut is tightened on the back of the screw.

various areas of construction and plumbing use risers. It can be used to hold vertical water pipes on site at each building level. Slope clamps can also be used to hold a vertical pipe on site, either in the interior or outdoors. Standard terminals of the riser hold the vertical pipe on the spot through the rubbing of the clamp tightened around the pipeline; The arms reach behind the opening through which the pipe is lowered and holds the pipes in place from any gravitational stroke. Instead of the arms you can buy riser clamps with curved legs, allowing them to be screwed to the wall or other structure to hold the pipes in place and far from the wall.

The

riser switches come in different sizes to fit different pipes, pipes or pipes. Most riser clams are made of carbon steel, but come in different cannons for different types of building equipment. MeDr, electro-zinc, red-oxide Primer and epoxy are several coatings available for purchase, depending on the type of pipe or pipe installation. Copper coatings are used on copper pipes mainly for identification purposes, while the electro-zinc coating helps to ensure corrosion protection. Red-oxide and epoxy are recommended for suspension of vertical steel pipes.

IN OTHER LANGUAGES

Was this article helpful? Thanks for the feedback Thanks for the feedback

How can we help? How can we help?