What is a cutting board?
In the construct, the connecting plate is a thick metal sheet used to strengthen the connection between structural steel beams. The joint between two pieces of steel is known as a joint and each joint must be carefully reinforced to ensure safe bonds. Despite the high strength of steel beams and columns, the weak connection between two rays can endanger the structural integrity of the whole building. Adding a cutting board minimizes the risk of failure and helps to improve safety for residents of building. In some cases, there are simply no rays that are long enough for a specific application. In others, the beam can be full of length too difficult to transport in the workplace or even get in or out of the building. Finally, the spares of the beams can help workers to build steel around obstacles or maneuver them in the building without damaging the surrounding surfaces.
After placing two beams as needed, the montage is centered along the cut area. Can be placed on the web or on the beam notBo on chords, depending on access to the installation program and recommendations of engineers. Sometimes a single cutting board is used to ensure two beams, while other applications require two haircut boards for safer holding.
The plates are drilled before the manufacturer's holes. Installers put the board on the clutch and then insert the heavy screws into each hole. The steel nut holds the end of the screw in place and prevents the board from moving. Some engineers may also require workers to weld the circumference of the cutting board to maximize the strength and durability of the connection.
Platele spice provides much safer holding between two rays than screws or welding itself. The forces applied to the beam extends on a much larger area than they would be at the screws, as the board helps to distribute the joint. These plates also reduce the risk that the beams turn over or deform at the connection pointOjení, which helps to prolong the life of the structure.
Most building regulations provide specific requirements for the use of haircut boards. Engineers refer to these codes to determine the size, thickness, material and type of fasteners that must be used for haircut. The engineer can also make calculations based on forces and loads that will support the sleep to help it determine the best design of the cutting board.