What Is Actuator Cable?
Electric actuator (English: Electric actuator), also known as electric thermostat controller, is a new concept for remote control system flow, heat (cooling) device, suitable for residential, shopping mall, hotel heating Central air-conditioning temperature control, room temperature control.
Electric heating actuator
- Electric actuator (English: Electric actuator), also known as
- Electric heating actuator is mainly used for floor heating
- The electric heating actuator is composed of a temperature controller, a valve actuator and a valve. The thermostat is installed on the interior wall of the room and is connected to the electric heating actuator with a cable. Generally, the actuator is connected to the selected control point with a 100cm cable (temperature controller, programmer, timer or other remote control). Device). The actuator is connected to the valve with a nut. When the indoor temperature reaches the temperature set by the temperature controller, the positive thermistor in the electric actuator starts to work, and the thermal expansion device closes the valve. On the contrary, the indoor temperature decreases, the thermostat disconnects, the actuator cools down, and the expansion device contracts. The valve opens. Generally imported and domestic brands have automatic reset function when power off
- The actuator is suitable for installation at
- Radiator thermostat
- Two-way valve
- Trap
- Application of electric heating actuator
- For radiator
- For underfloor heating systems
- Used as a zone valve
- For air conditioning systems
- The electric heating actuator is installed on the water separator. The main function of the electric heating actuator is to start the water stop when the water temperature reaches the set value, so as to control the temperature. Reverse, it will not work.
- It is generally used in desulfurization of power plants, water supply and drainage of sewage treatment plants, and pipes in paper mills ... It is used in many places. Some small actuators control small disc valves \ stop valves \ dampers ... etc. Before the ignition, it is necessary to blow the air in the furnace. During the blowing, the electric actuator can be used to control the valve from open to close or from close to open. Actuators are generally divided into electric actuators and pneumatic actuators. From the control method, they are divided into switch type and adjustment type. The switch type is just to control the valve from open to closed or from closed to open. The regulating type means that the actuator can control the valve to adjust back and forth in the middle or a certain position through the actuator.