What is the undercut?

SHORT is a tool used in the processing and construction of wood. The subordinate saw is very similar to the standard circular saw. In fact, it is basically a circular saw upside down. Although it is used to cut materials, the sawing of the saw has a slightly different function and purpose than a standard circular saw.

When installing underfloor materials, such as wood into an existing house or building, it may be necessary to crop the hard work or lining so that the floor fits under the door. This is particularly necessary when the carpet is replaced by a solid floor. After the carpet is used, the chicken and lining up to the floor are installed, causing problems when installing a solid floor. When the solid floor replaces the carpet, it is usually necessary to cut off the JAMB and crop just above the floor. If this does not happen, the result after retaining the floor is an unattractive gap that extends to the floor.

The process of cutting the lining and laws was manually carried out before the invention of the sawing of the saw because there were no tools toThey were able to cut parallel to the floor and as close as possible to the floor as needed. The part between the edging and the floor is usually about 1.75 inches (about 4.45 cm), so the engines on regular saws were too large in this space. The only options were to either trim or remove trim and jam and then crop them. Both options were time consuming and required a large amount of precise cutting.

subclated saws consist of a rotary electric motor that controls a circular saw blade in a horizontal way. The cutting assembly is governed by a base that provides not only a stable cutting surface, but also a non -sliding action. The blade is attached to the flange that extends from the plane, and this blade is then attached to the drive shaft and configure in a way that allows it to be used in parallel with the floor.

The blade can be set vertically, but the method has its shortcomings. Usually it is a slow process and the fasteners need manual settings. Due to the needPeripheral modifications are often difficult to ensure that the blade remains at the level.

Subborn saws also usually provide vacuum connections for safety reasons. This connection ensures that all cuttings are captured. Unfortunately, peripheral height adjustments often disrupt the vacuum attachment, so it occasionally uses comprehensive and difficult use of undercut.